Our back deck comes straight off our living room, which means it sits pretty high up off the ground. I like the ease of going in and out (especially since we put in a really wide patio door for that “inside-outside” vibe), but I didn’t love being able to see over into our neighbours backyard.
The solution? We built a privacy screen for our deck that has made ALL the difference.
Not only does it provide the privacy we were after, but it has also made styling the deck so much easier!
Supplies You’ll Need:
We LOVE these Ryobi cordless tools (this isn’t a sponsored post, I just genuinely wanted to mention how much we love their tool set. We seem to be collecting the whole line!)
How to Build a Privacy Screen for your Deck:
Keep reading for the step-by-step tutorial.
Step 1: Assemble Lumber and Supplies
Based on the size of your deck, you’ll need to pull together the lumber for the screen.
You need lumber for both the upright posts and the ones that will plank horizontally across.
We used pressure treated 4×4 lumber for the 4 upright posts. For the horizontal posts, we used 16 ft long pressure treated deck planks.
Step 2: Build the Frame
It’s important to look at the building codes for your specific region to make sure that the privacy screen meets the local regulations (both height and how they are attached & built).
The 4×4 posts used to support the screen are bolted onto the deck frame and secured according to local regulations. They extend down into the ground to ensure stability of the posts.
Step 3: Fasten Horizontals
We used a wood chip between the planks as we put them up, to ensure that they would all have the same spacing between them.
We also trimmed off the top of the posts, in line with the deck boards.
Step 4: Paint
If you want a wood-look to your privacy screen, then you could just stop here.
Because we already have a lot of brown going on in the deck and furniture itself, I knew I wanted to paint our privacy screen white.
I used an outdoor water-based paint, in off-the-shelf white. I personally used a brand from Canadian Tire, but the brand doesn’t matter so much – what matters is that it is a paint meant for outdoor application.
I applied the paint with an angled brush instead of a roller, because it was easier that way to get into the nooks and crannies. Two coats of paint, and it was finished!
Step 5: Accessorize
Once the screen was up, I was finally able to accessorize the lounge area. I’m not done yet, but it’s started to look cute!
The outdoor sectional is from IKEA, the striped outdoor cushions are from Wayfair, and the plants are “majesty palm” trees planted in black planters from Costco. The coffee table and wicker chair were both garbage-picked. Can you believe it?
We are majorly enjoying lounging out on the deck now. A cute and private space!
Pin it for later: